Philips AZ1007/01 - Manual (Page 2)

CONTROLS P WER SUPPLY
8) O; (no; (11)
( 7 ) ' 5 ;
[ top AND FRONT PANEL
(i) Source selector - tu sel«rt source of sound:
^ CD-RADIO-TAP: and also the POWER OFF
switch.
VOLUME - to adjust volume level.
(3) DBB - Dynamic Bass Boost: for a more vivid
bass response.
CASSETTE RECORDER:
(i' PAUSE II - to interrupt rccordirg or playback.
STOP'OPEN ■ 4 - To strip tlie tape and In
open die cassette holder,
SEARCH or - to fast wind/rewlnd the
tape.
PLAY A - to start playback.
RECORD • - to start recording.
' s) Cassette compartment
CD PLAYER:
(6; CD Display ' to sh(jw the CD tunctiens.
(7) PLAY*PAUSE ►!! - To start or interrupt
CD play.
STOP! - to stop playback or erase a
programme.
CD MODE - to select a different play mode,
e.g. SHUFFLE/REPEAT; to programme and
review programmed track numbers
SEARCH or - to skip or search a
passage/track backwards or forward
(e) LIFT TO OPEN - to open/dose the CD door
RADIO:
:is) BAND - to select FM/MW wave band
io) Tuning dial pointer
'll TUNING -totune to radio stations
BACK PANEL
:;í
2
i Battery door to open the battery
compartment
■:;i3) BEAT CUT switch - To eliminate any w'histle
tones during MW recordings.
; h ) Telescopic aerial - to improve FM
reception
(;i5) 0 ■ 3.5 mm stereo headphone socket
fl/ofe;Cannecling headphones will switch otf the
loudspeakers
(Í6j AC MAINS - socket for mains lead
Batteries
Whenever convenient, use the mains supply if you want to
conserve battery life. The battery supply will he switched otf when
the set is connected to the mains. Make sure you remove the plug
from the set and wall outlet before inserting batteries.
Batteries (optional)
1. Open the battery compartment and insert six battorics, type R2Û,
UM1 or D-cells {preferably alkaline) witti tfie correct polarity as
indicated by the (+) and [-) symbols inside the compartment.
2. Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
- Incorrect use of batteries can cause electrolyte leakage and will
corrode the compartment or cause the batteries to burst.
Therefore:
- Do not mix battery types, e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
■■■ When inserting new batteries, do not try to mix old batteries
with the new ones.
- Remove the batteries if the set is not to be used for a long
time.
Batteries contain chemical substances, so they should be
disposed of properly