Philips CDI740/05 - Manual (Page 11)

PLAYING DISCS
GENERAL
Push button controL
I’( ir play control you can use the buttons on one of the
following items;
• the front pannel of the CD-i player.
• the remote control.
• the on-screen function displayed on the TV.
The corresponding buttons on these items operate in the same way.
Sound leveL
• When playing any disc adjust the sound level as required,
preferably on the TV or HiFi amplifier.
• The volume up (15)/dovnn (16) buttons on the remote
control may also be used, but for each disc these controls
always start at the level set in the General Options Screens.
A suitable level must therefore first be set on the TV or HiFi
amplifier.
LOADING AND UNLOADING
Loading:
• Point and click on 'Open'
(you may also press the
OPEN /CLOSE button (11) on
the player) to open the disc
tray Ci;.
• Take the disc from its holder
and place it on the tray with
the label facing upw'ards.
• Point and click on 'Close' (you
may also press tlie
OPEN/CLOSE button (11) on
the player, or gently push the
front of the tray) to close the
tray.
- The IV screen changes according to the type of disc.
CAUnON
NEVER PUT MORE THAN ONE DISC AT A TIME INTO THE
CD-i PLAYER
Unloading:
• Point and click on 'Open' (you may also press the
OPEN /CLOSE button (11) to open the disc loading tray.
- The player start-up screen reappears on the TV.
• Take the disc from the tray and replace it in its holder.
• Point and click on 'Close' (you may also press the
OPEN/CLOSE button (11) on the player, or gently press the
front of the tray) to close the tray with or without a new disc.
NOTE
- You may unload the disc at any time by pressing the
OPEN/CLOSE button (11).
- Unloading a CD-i disc while the CD-i program is running, will
terminate the CD-i program abruptly. 'Bookmarks' or
intermediate results, if used by the CD-i program, might not
be updated to the latest situation.
PLAYING A CD-i DISC
Pluy'ing a CD-i disc depends on the value of Autoplay (see
Options Screens). The factory^ setting is default "OFF".
l.When autoplay is "OFF":
After the disc is loaded, the
CD-i start-up screen appears on
the TV'. To start the CD-i
program, select 'Play' and click
on it.
2. When autoplay is "ON":
After the disc is loaded, the CD-i program will start up
automatically.
- This procedure applies equally to all disc standards.
The opening screen of the CD-i program now appears on the TV.
From this point, all interaction is between you and the program.
To stop at any time, select the STOP or EXIT function provided
by the CD-i program.
CAUTION
NEVER LEAVE A STDLL PICTURE ON THE SCREEN FOR ANY
LENGTH OF TIME. THIS CAN CAUSE BURNING IN OF THE
PICTURE TUBE. TO AVOID THIS, SWITCH OFF THE PLAYER
OR REMOVE THE DISC.
11