Casio IT-2000D - Manual (Page 81)

81
4.2 How to Write CONFIG.SYS and AUTOEXEC.BAT
This section explains how to write the CONFIG.SYS and AUTOEXEC.BAT files mentioned in the
previous section. A basic explanation of the CONFIG.SYS and AUTOEXEC.BAT is not given here.
For further information about these files refer to the MS-DOS manual or appropriate technical
documents. Observe the following points if writing a CONFIG.SYS file.
The System Driver (SYSDRV.SYS) is required to operate this terminal.
Always include a line through which to load the System Driver in the CONFIG.SYS.
As described above, MS-DOS, which is in the basic drive, is always loaded.
Consequently, C:
COMMAND.COM is used as the command interpreter. Therefore, set a path
to COMMAND.COM to be reloaded in CONFIG.SYS using the SHELL command.
Within CONFIG.SYS the MENU command can be used. Note however, that no power off
command is included in the MENU selection screen. This is to prevent the power from being
accidentally turned off while loading the drivers. The Power switch is also disabled until the
CASIOAPM.COM program is initiated from AUTOEXEC.BAT, etc. In other words, the MENU
command should only be used in the application program development processes.
Example of CONFIG.SYS
The following example shows a typical CONFIG.SYS file script. Since this example assumes that
the system is booted from either the RAM disk or NAND F-ROM drive, it is necessary to partially
modify it if booting up from the ATA card. For information about booting from the ATA card refer
to Chapter 4.3, “Card Boot”.
FILES=30
Not required
BUFFERS=20 Not required
DOS=HIGH, NOUMB Required (1)
DEVICE=C: SYSDRV.SYS Required (2)
DEVICE=C: HIMEM.SYS /M:2 Required (3)
DEVICE=C: POWER.EXE Required (4)
DEVICE=C: TIME.SYS Required (4)
DEVICE=C: EMM386.EXE FRAME=C800 X=C000-C7FF X=D800-DFFF I=C800-D7FF Required (5)
SHELL=C: COMMAND.COM C: /P /E:1024 Required
DEVICE=C: CARDSOFT SS365SL.EXE /SKT=1 Required (6)
DEVICE=C: CARDSOFT CS.EXE /POLL:1 Required (6)
DEVICE=C: CARDSOFT CSALLOC.EXE
Required (6)
DEVICE=C: CARDSOFT ATADRV.EXE /S:1
Required (6)
DEVICE=C: CARDSOFT MTSRAM.EXE
Required (6)
DEVICE=C: CARDSOFT MTDDRV.EXE
Required (6)
DEVICE-C: CARDSOFT MTDAPM.SYS
Required (6)
DEVICE=C: CARDSOFT CARDID.EXE
Required (6)
INSTALL=C: CARDSOFT CS_APM.EXE
Required (6)