Philips AZ 8070 - Manual (Page 6)

BASIC FUNCTIONS RADIO
Switching on and off/standby
‘S.
U)' • Set the POWER ON selector to the desired sound source:
CD-TAPE/OFF-RADIO.
• The set is switched off when the POWER ON selector is in
position TAPE/OFF and the recorder keys are released.
• In order to switch off the power supply, remove the rhains plug.
Note: When operating the set with batteries, always be sure to
set the POWER ON selector to position TAPE/OFF when the set is
not used. This will avoid a permanent power consumption.
Adjusting volume and sound
Adjust the sound using the controls VOLUME and DBB and
INCREDIBLE SURROUND.
Use the rotary knob to in- or decrease the phenomenal stereo
sound. The surround effect varies from 0% to 100%.
The bass frequencies can also be emphasised if you place the set
against a wall or bookshelf. (Do not cover any vents and leave
sufficient room around the unit for ventilation.)
/"TT" /
o-
/ 0
Vo
RADIO - tuning to radio stations
1 Set the POWER ON selector to RADIO.
2 Select the wave band by using the selector FM-MW-LW.
3 Tune to the desired radio station by using the TUNING knob.
Improving the RADIO reception
• For FM, pull out the telescopic antenna. To improve the FM
signal, incline and turn the antenna. Reduce its length if the
signal is too strong (very close to a transmitter).
• For MW and LW, direct the built-in antenna by turning the whole
set. The telescopic antenna is not needed.