Specifications, Regulatory information, Contact information – Interlogix ATP1000 User Manual
Page 5

ATP1000 Touchpad/Display Installation Instructions
5
used by any bus device. See the specific panel Installation
Instructions for more information on deleting unused unit
numbers.
Specifications
Compatibility
Concord, Concord Express, Concord Ultra
Power requirements
12 VDC nominal (see
Figure 1
for additional
power requirements)
Operating temperature
32° to 120°F (0° to 49°C)
Humidity
95% relative, non-condensing
Dimensions
5.0” x 4.5 x .75” (L x W x D)
Regulatory information
Manufacturer
UTC Fire & Security Americas Corporation, Inc.
1275 Red Fox Rd., Arden Hills, MN 55112-6943,
USA
UL listings
UL 985 Household Fire Warning System Units
UL 1023 Household Burglar-Alarm System Units
UL1610 Central Station Burglar-Alarm Units
(Commercial Burglary)
Note: See specific panel Installation Instructions
for complete UL installation requirements for the
system you are installing
FCC compliance
FCC Part 15 Information to the User
Changes or modifications not expressly approved
by Interlogix can void the user’s authority to
operate the equipment.
FCC Part 15 Class B
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against interference in a residential
installation.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
•
Reorient or relocate the receiving
antenna.
•
Increase the separation between the
equipment and receiver.
•
Connect the affected equipment and
the panel receiver to separate outlets,
on different branch circuits.
•
Consult the dealer or an experienced
radio/TV technician for help.
Contact information
For contact information, see www.utcfireandsecurity.com or
www.interlogix.com.
For technical support, Toll-free: 888.437.3287 in the US
including Alaska, Hawaii, Puerto Rico, and Canada. Outside
the tool-free area: Contact your dealer.
Copyright © 2011 Interlogix, a UTC Fire & Security Company.
All rights reserved.