Interlogix NX-4 - Manual (Page 40)

NX-4 Control
Page 38
Notices
(Applies to products which
have the CE mark attached)
DECLARATION OF CONFORMITY
Manufacturer’s Name: Caddx Controls
Manufacturer’s Address: 1420 N. Main Street
Gladewater, TX
75647
EU Representative:
Interlogix Europe
Product Identification
Product:
NetworX
Model: NX-4
Brand: CADDX
R&TTE Directive
See EMC and LVD tests below
EMC Directive
EN50081-1
EN50130-4
EN55022
EN60950
EN61000-3-2
EN61000-3-3
LVD Directive
EN 60950: 1999-4 3rd edition
Means of Conformity
We declare under our sole responsibility that this
product is in conformity with Directive 1999/5/EC
(R&TTE); Directive 73/23/EEC (LVD); and
Directive 89/336/EEC (EMC) and based on test
results using (non)-harmonized standards in
accordance with the Directives mentioned.
Additional Tests
This equipment has been tested and found to
comply with the following standards (which are no
longer required for compliance).
Network Compatibility Declaration
We declare under our sole responsibility that this
product is designed to work with the networks in
the countries marked with a check ( ) and may
have interworking problems with the countries that
are not checked. Due to the inherent differences in
the individual PSTNs, certain software settings
may need to be adjusted on a country-to-country
basis. If it is desired to use this equipment on a
network other than the one on which it was
originally installed, you should contact your
equipment supplier.
( ) Austria (_) Liechtenstein
( ) Belgium ( ) Luxembourg
( ) Denmark ( ) Netherlands
( ) Finland ( ) Norway
( ) France ( ) Poland
( ) Germany ( ) Portugal
( ) Greece ( ) Spain
( ) Iceland ( ) Sweden
( ) Ireland ( ) Switzerland
( ) Italy ( ) United Kingdom
Telecom Approval Notice
This equipment has been approved in accordance
with the Council Decision 98/482/EC for pan-
European, single terminal connection to the public
switched telephone network (PSTN). However, due
to the differences between the individual PSTNs
provided in different countries, the approval does
not, of itself, give an unconditional assurance of
successful operation on every PSTN network
termination point. In the event of problems, you
should contact your equipment supplier in the first
instance.
Electrical Requirements
This device automatically adjusts to voltages
within the range of 230 V 50/60 Hz.
Fuse: Type T 200mA 250 VAC