Interlogix Concord Express User Manual - Manual (Page 57)

Concord Express User Instructions 51
To change or assign a user access code:
Note
: The system will not accept the same code for two different users.
1. Enter the programming menus by pressing 9 + System Master Code.
2. Press B until the touchpad displays “USER CODES,” then press #.
3. Press B until the touchpad displays the type of code you wish to change
(Regular User codes or System Master code), then press #.
4. For example, if you want to change a Regular User code, press # when the
touchpad displays “REG CODES.”
5. Press B until the touchpad displays the user code you wish to change, then
press #.
For example, if you want to change Regular User code 2, press # when the
touchpad displays “REG CODE 02.”
6. Enter the new code and press # .
7. Press B. “BYPASS on/off” appears:
• Press 1 + # to turn the option off for this user code.
• Press 2 + # to turn the option on for this user code.
1. Press B. “TESTS on/off” appears:
• Press 1 + # to turn the option off for this user code.
• Press 2 + # to turn the option on for this user code.
1. Press * + B to move to the next user code, or * + 4 + # to exit programming
menus.
To erase a user code:
1. Enter the programming menus by pressing 9 + System Master Code.
2. Press B until the touchpad displays “USER CODES,” then press É.
Note
: You cannot delete the System Master Code.
3. The touchpad displays “REG CODES.” Press #.
4. Press B until the touchpad displays the user code you wish to erase, then
press #.
For example, if you want to change User code 4, press É when the touchpad
displays “REG CODE 04,” or “USER 04.”
5. Enter the System Master code you used in Step 1 and press #. The deleted
code appears as “REG 04 ----”.
6. Press * + B to move to the next user code, or * +4 + # to exit the programming
menus.