Interlogix Concord Express User Manual - Manual (Page 39)

Concord Express User Instructions 33
Press B to display the system number. For example, “N – nnnnnnn,” or
“SYSTEM NUMBER * nnnnnnn.”
Press B to display the system level. For example, “L nnnn,” or SYSTEM
LEVEL nnnn.”
3. Press * + 4 + # to exit the programming menus.
Testing the System
The system contains a test mode that allows you to test sensors and panic
signals without creating false alarms. Test your system weekly, by following the
instructions in this section carefully.
Automatic Test Features
Your security system conducts routine tests, checking for problems like power
failures, low batteries, sensors that aren’t working, and communication trouble
with the central monitoring station.
When your system detects a problem, trouble beeps sound to alert you. See
“Troubleshooting” for an explanation of the causes of trouble beeps and what you
can do to fix the problem.
Manual Tests
The automatic tests your system performs provide continuing reassurance that it
is working properly. There are also weekly system tests you can do yourself as
an added safeguard. Taking time to do these tests will familiarize you with your
system and alert you to anything unusual, such as cut phone lines or sensors
that have been tampered with.
The ability to conduct sensor and phone tests is a code attribute given per User
code.
Sensor Test
Note
: Make sure system is disarmed when performing sensor tests.
This test verifies that the sensors in your system are operating correctly.
Sensor test reports are sent to the central station at the beginning and end of
system tests.
To initiate a sensor test
1. Press 8 + Code + 3. Touchpads display, “Press Status. System Armed to
Sensor Test,” or “*SENSOR TEST nn MINUTES LEFT.” When less than 5