Interlogix Concord Express User Manual User Manual
Page 41
Concord Express User Instructions
35
• If the phone test is unsuccessful, the touchpad displays “SYSTEM PHONE
TEST ALARM,” then, “MEMORY,” and finally, “PHONE FAILURE ALARM
MEMORY.”
If a phone test is unsuccessful, check to see if you hear a dial tone from phones
in the house. Call your dealer if you hear a dial tone, but your phone test is
unsuccessful.
Testing Sirens
The purpose of this weekly test is to verify that the panel is activating sirens with
the appropriate warning sounds.
To perform an alarm siren warning sound test:
1. Contact the central monitoring station to inform them that you will be
activating alarms and they should not dispatch authorities.
2. Activate alarms of each type (fire, police, auxiliary), one at a time.
3. Listen for the appropriate siren sound when each alarm is activated (see the
“System Alarm Sounds” on page 20.
4. Contact the central monitoring station to inform them that you are finished
activating alarms.
Table 3: Testing sensors and zones
Device
Test procedure
Touchpad result
Touchpads
Send a:
•
Police panic alarm,
•
Fire panic alarm, and
•
Auxiliary panic alarm.
•
Touchpad Panic
POLICE
OK
•
Touchpad Panic
FIRE
OK
•
Touchpad Panic
AUXILIARY OK
•
POLICE PANIC OK
•
FIRE PANIC OK
•
AUXILIARY PANIC OK
Wireless Touchpads
Press the Bypass key.
•
Zones nn OK
•
SENSOR nn OK
OR
•
Touchpad Panic
POLICE
OK
•
POLICE PANIC OK
Panic buttons
Press and hold the appropriate
panic button(s) for 3 full
seconds.
•
Zones nn OK
•
SENSOR nn OK