Interlogix POE201-EX - Manual (Page 10)

4 IFS POE201-EX POE Extender User Manual
Hardware Installation
The POE201-EX operates at two different data rates – 10Mbps
and100Mbps in the same device and automatically adjusts
based on the speed of incoming connection.
The following section describes the hardware features of the
POE201-EX. Carefully read this section before connecting any
network device to this unit.
Before Installation
It is recommended to check the network environment before
the installation. The POE201-EX conveniently extends the
distances in an installation base by transferring power to the
remote PDs. (Powered Devices).
The POE201-EX is installed between the PSE (Power Source
Equipment) and the PD (Powered Device); it is powered by
PSE and forwards the Ethernet data and remaining POE
power to the PD. The POE201-EX doesn’t require an external
power supply and it can be installed easily just plug and play;
that means the operator does not need to configure the
POE201-EX. The POE201-EX injects power to the PDs
without affecting the data transmission performance. It offers a
cost effective and quick solution to extend power and data for
an additional 328 ft. (100m).
Note: The POE201-EX can be installed with third-party
devices as long as the connected device complies with the
IEEE 802.3af standard.
Power Source Equipment (PSE) Installation
1. Connect a standard Cat5e/6 UTP cable from Power Source
Equipment (PSE), such as PoE Switch, PoE Injector hub or
a single port PoE injector, to the “IN” port of POE201-EX.