Interlogix MC352-1P/1S - Manual (Page 19)

IFS MC352-1P/1S User Manual 15
Stand-alone Installation
Please follow these steps to install the MC352-1P/1S:
The SFP transceivers are hot-swappable, you can insert or
remove the transceiver from an SFP port without having to
power down the Industrial 802.3at PoE Media Converter.
To install the MC352-1P/1S with 100Base-FX, 1000Base-SX /
LX SFP, simply complete the following steps:
Step 1
: Insert in the 100Base-FX, or 1000Base-SX / LX SFP.
Make sure the same type of SFP modules are used on both
side, i.e. 100Base-FX / 2km to 100Base-FX / 2km, 1000Base-
SX / 220m & 550m to 1000Base-SX / 220m & 550m, etc.
Step 2: Connect the fiber cable. Attach the duplex LC
connector on the network cable into the SFP transceiver.
Note:
It is recommended to use 1000Base-SX / LX SFP
modules available in the IFS Transmission product line. A SFP
transceiver module that is not supported will not be recognized
by MC352-1P/1S media converter.
The following list provides the available SFP modules for the
MC352-1P/1S.