Mounting installation, Mounting to a din-rail, Mounting installation 8 – Interlogix MC352-1P/1S User Manual

Page 12

Text mode
Original mode

8 IFS MC352-1P/1S User Manual

Note:

The wire gauge for the terminal block should be in the

range between 12 ~ 24 AWG.

The alarm relay circuit accepts up to 30V, max. 3A currents.

Mounting Installation

This section describes how to mount the MC352-1P/1S and
make connections to it. Please read the following sections and
perform the procedures in the order presented.

Note:

In the installation steps below, this Manual uses the IFS

GE-DSGH-8 as an example. However, the steps for any IFS
Industrial Switch & Industrial Media Converter are similar.

Mounting to a DIN-Rail

The DIN-Rail kit comes assembled on the MC352-1P/1S out of
the box. Please refer to following figures to mount the MC352-
1P/1S on a DIN-Rail.