Interlogix MCR200-1T-1TW - Manual (Page 17)

14 IFS MCR200-1T-1TW User Guide
Connecting Multiple PCs to an Ethernet LAN
Refer to the following procedures to setup the MCR200-1T-1TW to an
Ethernet LAN.
1. Set the MCR200-1T-1TW to be CO or CPE mode from the DIP switch at
the rear panel.
2. Power on the MCR200-1T-1TW by connecting its power source.
3. Power LED will illuminate.
4. Connect VDSL line from another VDSL device to VDSL port of
the MCR200-1T-1TW. LNK LED will illuminate.
5. Connect telephone to the PHONE port.
6. MCR200-1T-1TW: Connect Ethernet port to Ethernet Switch (or Broadband
Router) via regular Cat. 5, 5e or 6 cables.
Figure 3-5: Connecting Multiple PCs to an Ethernet LAN
Please refer to your Ethernet device User’s
Manual for the device’s set up information.