Interlogix MC350-4T-2S User Manual

Page 26

Installation Steps

Step

Unpack the Industrial Gigabit Ethernet Switch.

Step 2:

Check whether the DIN-Rail is screwed on the Industrial Gigabit Ethernet Switch. (Please refer to DIN-Rail

Mounting section for DIN-Rail installation if the DIN-Rail is not screwed on the Industrial switch). If you want to wall

mount the Industrial Gigabit Ethernet Switch, then please refer to the Wall Mount Plate Mounting section for wall

mount plate installation.

Step 3:

To hang the Industrial Gigabit Ethernet Switch on the DIN-Rail track or wall, please refer to the Mounting

Installation section.

Step 4:

Power on the Industrial Gigabit Ethernet Switch. (Please refer to the Wiring of the Power Inputs section for power

input) The power LED on the Industrial Gigabit Ethernet Switch will light up. Please refer to the LED Indicators

section for the functions of LED lights.

Step 5:

Prepare the twisted-pair, straight through Category 5 cable for Ethernet connection.

Step 6:

Insert one side of Category 5 cables into the Industrial Gigabit Ethernet Switch Ethernet port (RJ-45 port) while the

other side of category 5 cable to the network devices' Ethernet port (RJ-45 port), e.g. switch, PC or Server. The

UTP port (RJ-45) LED on the Industrial Gigabit Ethernet Switch will light up when the cable is connected with the

network device. Please refer to the LED Indicators section for the functions of LED lights.

Step 7:

When all connections are all set and LED lights all show normally, the installation is complete.

Make sure the connected network devices support MDI/MDI-X. If it does not support,

then use the crossover category 5 Cable.