Intellijel Korgasmatron II - Manual (Page 41)

CV
CUTOFF/BANDWIDTH
(BR1 + LP1) filter patch
39
Monitoring (BR1 + LP1) filter at OUT B in SERIAL
configuration.
(BR1 + LP1) CUTOFF shift :
Manually set A & B cutoff, with
A band-reject cutoff
always < B low-pass cutoff . Keep same relative knobs
position for cutoff shift.
OR/AND
Input same CV signal in A & B FM 1 with same attenuation
levels.
OR/AND
Use FM 2 normalled input and set FM 2 B as FM 2 A.
(BR1 + LP1) BANDWIDTH set :
Manually set A & B cutoff, with
A band-reject cutoff
always < B low-pass cutoff . Keep different relative knobs
positions for bandwidth set.
OR/AND
Input different CV signals in A & B FM 1 with different
attenuation level.
OR/AND
Use FM 2 normalled input and set FM 2 B as inverted of
FM 2 A.
See (BR1 + LP1) filter chart for details on OUT B filter
curves.
(BR1 + LP1) out
signal to be
filtered
CUTOFF/BANDWIDTH
set with
A band-reject
always < B low-pass
CV
CUTOFF/BANDWIDTH
A B
out
freq.