Intellijel Korgasmatron II - Manual (Page 39)

CV
CUTOFF/BANDWIDTH
(BP1 + HP2) filter patch
37
signal to be
filtered
CUTOFF/BANDWIDTH
set with
A band-pass
always < B high-pass
CV
CUTOFF/BANDWIDTH
Monitoring (BP1 + HP2) filter at MIX in PARALLEL
configuration with 1:1 XFADE.
(BP1 + HP2) CUTOFF shift :
Manually set A & B cutoff, with
A band-pass cutoff always
< B high-pass cutoff . Keep same relative knobs position
for cutoff shift.
OR/AND
Input same CV signal in A & B FM 1 with same attenuation
levels.
OR/AND
Use FM 2 normalled input and set FM 2 B as FM 2 A.
(BP1 + HP2) BANDWIDTH set :
Manually set A & B cutoff, with
A band-pass cutoff always
< B high-pass cutoff . Keep different relative knobs
positions for bandwidth set.
OR/AND
Input different CV signals in A & B FM 1 with different
attenuation level.
OR/AND
Use FM 2 normalled input and set FM 2 B as inverted of
FM 2 A.
See (BP1 + HP2) filter chart for details on MIX out filter
curves.
A B
out
freq.
(BP1 + HP1) out