IC Realtime 2Megapixel HD Network Fish-Eye Camera (ICIPD2360) - Manual (Page 10)

I C R E A L T I M E S E C U R I T Y S O L U T I O N S
7
2.b Step by Step Guide
 Step 1: Remove the cameras dome cover
Using the included hex wrench from the accessories kit, unfasten the 3 hex screws on the dome camera
enclosure and then remove it.
 Step 2: Place mounting template
Included with the camera is a mounting template that can be adhered to the target installation surface for ease
of installation. Following the diagram, bore 3 small holes as indicated on the diagram, around the perimeter of
the template. Once you’ve created your holes, insert the plastic anchors securely and firmly.
If you need to pass the cameras cable through the mounting plate, be sure to bore out the template area marked
‘Cable Exit’ to allow for the female RJ-45 plug to pass through.
If you need to pass the cameras cable through the side of the cameras enclosure, be sure to snip out the U-
shape knock out in order to allow the cable a wire path.
 Step 3: Mount camera base
Adjust the cameras base plate, and pull the cable through your exit hole. Match the ”TOP” direction of the
camera with that from the installation template. Align the 3 base plate holes with the plastic anchors from Step
2. Using (3) ST3.0 self tapping screws from the accessories kit, fix the camera base plate onto the installation
surface by screwing the ST3.0 screws through the holes, and into the plastic anchors.
 Step 4: Replace dome cover
Lastly, take the dome cover and align it with the base plate that is now fixed to the installation surface. Using
the hex key from step 1, replace the 3 hex screws, securing the dome back in place.