beautypg.com

IC Realtime PTZ-2801WDR: High Speed PTZ Dome Camera with 28X Zoom User Manual

Page 27

background image

20

PRESET NO :001

TITLE :PRESET001

SETTING

CALL

BACK

z

TIME TASK: Move the cursor to TIME TASK and then click confirm button to go to the third submenu.

z

NEXT PAGE: It includes: PRIVACY MASKING, PTZ SPEED, SET ZERO, POWER UP, MENU

PASSWORD, MENU IDEL, PTZ AUTO STOP, and HEATER. Move the cursor to the item and then
click the confirm button to set. .

z

BACK: Go back to previous menu.

z

EXIT: Log out system menu.


4.4.4.1 Preset Setup






Move the cursor to PRESET button and then click confirm button to go to set interface.
z

PRESET NO: Please use left/right key to modify preset number. The different protocols support

different preset values. The PELCOD and PELCOP support 1 to 255. For the industrial protocol, the
value ranges from 1 to 80.

z

TITLE

:Title text is the label used for you to identify the camera. System will automatically name a title

for the camera.

z

SETTING: Please input preset number first and then select the monitor zone. Please move the cursor to

setting and click confirm button. The system will pop up a message: PRESET: ***. Here *** means
preset number. And the SETTING column pops up an OK. Now you successfully added a preset.
Please note, you need to enable display preset title function first (Main menu->display setting->preset
title).Repeat the above procedures to set more presets. Once you want to modify a preset, you can
input the preset number you want to modify and then follow the above steps to set the preset. You can
successfully modify a preset content.

z

CALL: Here is to recall preset. Move the cursor to PRESET NO and then input corresponding preset

value. Then move the cursor to CALL and then click confirm button to go to a preset.

z

BACK: Go back to previous menu.

z

EXIT: Log out system menu.

For PELCO protocol user, please refer to the following special functions:
z

Call preset: Call preset 28 or preset 95 to go to dome menu. Call preset 29 or preset 99 to go to scan.

Call preset 24 or preset 81 to go to pattern. Call preset 25 or preset 82 to go to cruise (tour). Call preset
30 or preset 96 to stop scan or pattern. Call preset 31 or preset 83 to begin rotation. Call preset 33 to
enable PTZ 180 degrees rotation. Call preset 34 to set dome position as 0.

z

Set preset: Set preset 26 or 92 to set scan left limit. Set preset 27 or 93 to set scan right limit. Set

preset 22 or 79 to begin record. Set preset 23 or 80 to stop record.


4.4.4.2 Pan




PAN SPEED :160

RUN

STOP

BACK

EXIT

This manual is related to the following products: