IC Realtime PTZ-2801WDR: High Speed PTZ Dome Camera with 28X Zoom - Manual (Page 19)

12
ADDR ：
BAUD RATE ：
PARITY ：
PROTOCOL ： PELCO-P
SOFTWARE ：V1.04.3
BACK
EXIT
SYSTEM INFORMATION
DISPLAY SETTING
CAMERA SETTING
FUNCTION SETTING
IR LIGHT SETTING
EXIT
The above diagram illustrates the overall structure of the speed dome setup menu.
Note:
z
ERR means current setup is invalid.
z Please make sure all the cable connections are right.
4.2 Self-diagnosis System Information
After installation, please connect speed dome to power. The system goes on a self-diagnosis, and then it
pops up the above interface to show the system information.
If there is anything wrong during the self-diagnosis, system pops up error code.
The above interface disappears after speed dome received the first command (or the display time lasts for 4
minutes.)
z
ADDR: Here you can view dome address information. For example, 001-H, 1 is the address number, -H
is hard address mode. –S is software address mode.
z Baud rate: Dome communication baud rate.
z Parity: Communication parity bit format.
z Protocol: System supports DH-SD1, PELCOD, and PELCOP by default (self-adaptive).
z Software: Dome software version of the control firmware.
When you are using the control keyboard or the matrix host to control the device via the RS485 BUS,
please make sure the control parameter of the keyboard or the matrix host is the same with the
speed dome OSD (including address, baud rate, parity). The protocol can be one of the protocols the
speed dome supported. Please make sure the cable connection is OK.
4.3 Main Menu
You can open the IP dome menu via monitor platform, Web, control keyboard, matrix, or speed dome
control terminal.
z SYSTEM INFORMATION：Dome self-diagnosis information, address information, system time setup,
set north direction, language, factory default setup, reboot and so on.
z DISPLAY INFORMATION: Display dome preset title, azimuth display, time, direction, dome internal
temperature and etc information.
z CAMERA PARAMETERS ：Display dome white balance setup, camera function setup, day/night setup,
shutter setup and etc.
z FUNCTION SETTING: Set preset, pan, scan, auto cruise, pattern, idle motion, time task and privacy mask
function.