HONDA 2000 Prelude - Owner's Manual - Manual (Page 59)

Indicator Lights
U.S. Anti-lock Brake
System (ABS)
Indicator
This light normally comes on for a
few seconds when you turn the
ignition switch ON (II), and when
the ignition switch is turned to
START (III). If this light comes on at
any other time, there is a problem in
the ABS. If this happens, take the
car to your dealer to have it checked.
With the light on, your car still has
normal braking ability but no anti-
lock. For complete information, see
page
156 .
Active Torque Transfer
System (ATTS) Indicator
Type SH only
This indicator normally comes on for
a few seconds when you turn the
ignition switch ON (II).
If it comes on at any other time,
there is a problem in the Active
Torque Transfer System (ATTS).
If this happens, take the car to your
dealer to have it checked. With the
indicator on, your car will corner
normally, but you will not have active
torque transfer.
Turn Signal and
Hazard Warning
Indicators
The left or right turn signal light
blinks when you signal a lane change
or turn. If the light does not blink or
blinks rapidly, it usually means one
of the turn signal bulbs is burned out
(see page 218 ). Replace the bulb as
soon as possible, since other drivers
cannot see that you are signalling.
When you turn on the Hazard
Warning switch, both turn signal
lights blink. All turn signals on the
outside of the car should flash.
Instruments and Controls
Canada
ABS
ATTS
Main Menu Table of Contents