Clarity 440 - Manual (Page 16)

Telephone Operations
Last Number Redial:
The last number dialed (up to 32 digits) is
stored in the redial memory until another
number is dialed.
To use this feature:
1. Press the TALK button.
2. When you hear the dial tone,
press the RD/P button.
3. The phone will automatically
dial for you.
Pause Feature:
Programming in a pause will cause the
phone to wait four (4) seconds before
dialing additional numbers. This feature
may be used when it is necessary to dial
an access code (9, for example) and
wait for a second dial tone before you
can dial an outside number. Press the
RD/P button at the required point during
the memory storage process to program
a pause.
Temporary Tone
If you have rotary (pulse) dial service, you
can change from pulse to touch tone (tone)
during a call.
1. Make phone call and wait until it
is connected.
16
Placing a Call
1. Press the TALK button (TALK button
will illuminate GREEN) and dial the
number you wish to call.
2. To end the call press the TALK button
or place the handset in the base.
Or
1. Press the keys of the numbers needed to
dial. The LCD will display PREDIAL and
the keys pressed.
2. Press the TALK button. Handset will go
off-hook and dialed the displayed
numbers.
Answering a Call
If the handset is out of the cradle, press the
TALK button.
If the handset is in the cradle with Auto-
Connect Mode ON, lift the handset. The
handset will be in receiver mode.
If the handset is in the cradle with
AutoConnect mode OFF, lift the handset. The
handset will be in standby mode. Press TALK
button to receive the call.
Refer to BOOST Clarity Power and Volume
Control for information on adjusting volume
controls on Page 14.
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 16