Clarity 440 - Manual (Page 12)

Feature Set-up
Setting Contrast
There are 3 contrast levels and the default is
set to level 2.
1. After setting the language, press UP( ▲ )
key to begin setting contrast.
2. The LCD display will show LCD
CONTRAST and 1 2 3.
3. Press the 1, 2 or 3 key to change the
level. The current selected level will be
highlighted.
4. Press the UP( ▲ ) or DOWN (
▼
) button
to go to the next menu.
Setting AREA CODE 1
1. After setting Contrast, press UP (
▲ )
button to set Area Code 1.
2. The LCD display will show “AREA CODE
1 and XYZ with X digit blinking.
3. Enter the area code number using the
numeric keys on the handset.
4. Press the UP ( ▲ ) or DOWN (
▼
) button to
go to the next menu.
Setting AREA CODE 2
1. After setting Area Code 1, press UP (
▲ )
button to set Area Code 2.
2. The LCD display will show AREA CODE
2 and XYZ with X digit blinking.
3. Enter the area code number using the
numeric keys on the handset.
4. Press the UP ( ▲ ) or DOWN (
▼
) button
to go to the next menu.
12
CALLER ID DISPLAY
Set-up Mode
C440 handset goes into setup mode automat-
ic when battery is connected.
Or press and hold MODE button for 3 sec-
onds to enter setup mode. If there is no input
within 30 seconds, the language will be set
to the last selected one and go back to stand-
by mode.
Setting Language
1. After entering setup mode, the LCD
display will show SEL LANGUAGE
and then 1.ENG 2.SPA
alternately with a tick mark against
the selected language.
2. Press 1 OR 2 button once to change
the language. The tick mark will move
against the new selection.
3. Press UP ( ▲ ) to go to the next menu.
Caller ID Screen
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 12