HONDA 2008 Fit - Owner's Manual - Manual (Page 66)

This indicator monitors the
temperature of the engine coolant. It
normally comes on when you turn
the ignition switch to the ON (II)
position and goes off after a few
seconds. In normal driving
conditions, this indicator should not
blink or stay on. In severe driving
conditions, such as very hot weather
or a long period of uphill driving, this
indicator may blink. This means the
engine coolant temperature is high.
If the indicator begins to blink while
you are driving, be sure to slow down
to prevent overheating. If the
indicator stays on, pull safely to the
side of the road and turn off the
engine. See page
for instructions
and precautions on checking the
engine’s cooling system.
This indicator monitors the
temperature of the engine coolant. If
there is no problem, this indicator
comes on when the engine is cold. If
it comes on when the engine is warm
(normal operating temperature),
have the vehicle inspected by your
dealer as soon as possible.
Do not drive the vehicle while the
indicator is on or the engine may be
damaged.
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page
). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle flash.
228
198
Instrument Panel Indicators
High Temperature
Indicator Low Temperature
Indicator Turn Signal and
Hazard Warning
Indicators
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
63 2008 Fit
Table Of Contents Main Menu