beautypg.com

Lights – HONDA 2008 Fit - Owner's Manual User Manual

Page 200

background image

Remove the electrical connector
from the bulb by pulling the
connector straight back.

Remove the rubber weather seal
by pulling on the tab.

Make sure that the hold-down
wire is installed properly and
securely. You can check its
installation from the inspection
window on the headlight assembly.

Install the rubber seal over the
back of the headlight assembly.

Unclip the end of the hold-down
wire from its slot. Pivot the wire
out of the way, then remove the
bulb.

Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.

5.

6.

3.

4.

7.

8.

CONTINUED

Lights

Ma

int
e

na
nce

197

RUBBER WEATHER SEAL

HOLD-DOWN
WIRE

BULB

ELECTRICAL
CONNECTOR

HOLD-DOWN
WIRE

INSPECTION WINDOW

2008 Fit

Table Of Contents

Main Menu