HONDA 2008 Fit - Owner's Manual - Manual (Page 118)

To play the radio when a CD is
playing, press the AM or FM button.
Press the CD button again to switch
back to the CD player.
To load or play CDs, the ignition
switch must be in the ACCESSORY
(I) or the ON(II) position.
You operate the CD player with the
same controls used for the radio. To
select the CD player, press the CD
button. The number of the track
playing is shown in the display. The
system will continuously play a CD
until you change modes.
Insert a CD about halfway into the
CD slot. The drive will pull the CD in
the rest of the way and begin to play
it. When the system reaches the end
of the disc, it will return to the
beginning and play the disc again.
You cannot load and play 3-inch
(8-cm) discs in this system.
If you turn the system off while a CD
is playing, either with the PWR/VOL
knob or by turning off the ignition
switch, the disc will stay in the drive.
When you turn the system back on,
the CD will begin playing where it
left off.
Each time you press and
release the side of the SKIP bar,
the player skips forward to the
beginning of the next track. Press
and release the
side, to skip
backward to the beginning of the
current track. Press it again to skip
to the beginning of the previous
track.
To move rapidly within a track, press
and hold the
or side.
To move rapidly within a
track, press and hold the SEEK/
SKIP bar. Press and hold
to
move forward. Press and hold
to move backward. Release the
bar when the system reaches the
point you want.
CONTINUED
All models except Sport
To Play a CD To Change or Select Tracks
SKIP
SEEK
Playing a Disc
Fe
a
tu
re
s
115
Do not use discs with adhesive labels.
The label can curl up and cause the
disc to jam in the unit.
2008 Fit
Table Of Contents Main Menu