Brake and clutch fluid – HONDA 2008 Fit - Owner's Manual User Manual
Page 198
Manual Transmission only
A low fluid level can indicate a leak
in the clutch system. Have this
system inspected as soon as possible.
The fluid level should be between
the MIN and MAX marks on the side
of the reservoir. If it is not, add
brake fluid to bring it up to that level.
Use the same fluid specified for the
brake system.
Check the brake fluid level in the
reservoirs monthly.
Replace the brake fluid according to
the time recommendation in the
maintenance minder schedule.
Always use Honda Heavy Duty
Brake Fluid DOT 3. If it is not
available, you should use only DOT 3
or DOT 4 fluid, from a sealed
container, as a temporary
replacement.
Using any non-Honda brake fluid can
cause corrosion and decrease the life
of the system. Have the brake
system flushed and refilled with
Honda Heavy Duty Brake Fluid
DOT 3 as soon as possible.
Brake fluid marked DOT 5 is not
compatible with your vehicle’s
braking system and can cause
extensive damage.
The fluid level should be between
the MIN and MAX marks on the side
of the reservoir. If the level is at or
below the MIN mark, your brake
system needs attention. Have the
brake system inspected for leaks or
worn brake pads/shoes.
Brake and Clutch Fluid
Clutch Fluid
Brake Fluid
Ma
int
e
na
nce
195
MIN
MAX
MIN
MAX
2008 Fit
Table Of Contents
Main Menu