Heckler&Koch P2000 User Manual

Page 12

Backstrap installation for all P Series pistols - Ensure the hammer strut and hammer spring

are properly positioned on the back of the frame (Figure 9). Place the replacement grip

panel on the back of the frame, approximately 1 inch (2.54cm) lower than its assembled

position (Figure 10), and push the grip panel up onto the grip rails.

Figure 9 Figure 10

Continue pushing the grip panel upward on the frame. As the grip panel slides upward

onto the grip rails, the hammer spring will compress slightly creating resistance. Continue

to slide the grip panel upward until it fits flush and there is no gap between the top of the

grip panel and frame.

At this point, the pin holes on the grip panel and the frame will line up. Carefully reinsert

the pin and push it through the grip panel and frame using finger pressure (Figure 11).

With the pin properly aligned in the grip panel and the frame, carefully tap the pin until it

is fully seated and centered in the frame (Figure 12).

Figure 11

Figure 12

Hold the Grip Panel in place while

Carefully tap the pin all the way back in.

Inserting the pin.

CAUTiON: Be careful not to damage the P Series when removing and installing

backstraps or grips panels.

interchangeable Side Panels and Backstraps - P30/P30L/P30S/P30LS Pistols
Three easily exchangeable back strap inserts/ grip shells of different heights enable a

perfect adaptation of the weapon to differing hand sizes.

Figure 13

Grip panels and backstraps (L-M- Standard)

removing the Grip Panels - First, follow the instructions for removing the P Series back-

strap. Once the back strap has been removed, the side panels will easily slide horizontally

away from the frame of the pistol.

installing the Grip Panels - First choose the grip panels which best fit your hand. Then

slide the grip panel horizontally into the grip slot. The grip panel will fit securely. Then,