Configuration using compatiview, Vpn client tunnel settings, Onfiguration – Compatible Systems INTRAPORT 2+ User Manual
Page 28: Sing, Ompati

22
Chapter 6 - Basic Configuration Guide
Configuration Using CompatiView
This section provides a list of parameters that must be entered into a
server for proper operation using CompatiView, Compatible Systems’
management software. If you wish to use the command line interface to
configure the server, see the next section in this chapter,
.
VPN Client Tunnel Settings
Configuration of the server for both dual and single Ethernet setups is
very similar, but when there are differences between them, the appro-
priate step for each setup is indicated.
v Note: Remember that in single Ethernet setups, Ethernet 1 must not
be connected to anything or else it may cause difficult to diagnose
problems on the IntraPort 2/2+ and on your network.
1. Turn off AppleTalk and IPX (optional).
If you are using AppleTalk and/or IPX, you can either leave the default
configuration parameters in place or see
for more information
on configuring those protocols. If you are not using AppleTalk and/or
IPX:
A. Click on the AppleTalk Routing protocol branch under Ether-
net 0. In the AppleTalk Routing dialog box select the Phase 2
Off radio button.
B. Click on the IPX Routing protocol branch under Ethernet 0. In
the IPX Routing dialog box select the IPX Off radio button
C. Click
OK.