Great Planes G-44 Widgeon Seaplane EP ARF - GPMA1151 - Manual (Page 6)

6
PREPARATIONS
Tighten the Covering
Refer to the separate instruction sheet titled How To Tighten
Covering On ARF Models . Follow the instructions to tighten
the covering. If you prefer to get started on assembly right
away, the tightening process could be done later (but it is
usually easiest to do while the model is still in separate pieces).
ASSEMBLE THE WINGS
Install the Motors
❏
1. There is a set of strings that are taped to the wing. A
string goes from the hole in the top of the wing by each of the
motor mount locations and exits out the hole in the bottom
center of the wing.
❏
2. Your kit includes six motor extensions.
Using the string on the top of the wing located by the motor
mount, tie the male end of three motor leads together and
then pull them through the wing until they exit out the hole in
the bottom center of the wing.
Do this for both of the holes by the motor mount.