Great Planes Fokker Dr-1 60 ARF - GPMA1380 - Manual (Page 10)

❏
4. Feel through the MonoKote and find the two pre-drilled
wing dowel holes on the leading edge of the center section
of the mid wing. Cut away the MonoKote.
❏
5. Using the two remaining 1/4" x 1-9/16" [6mm x 40mm]
wood dowels you marked on step 3 of the previous section.
Mix a small amount of epoxy and drop it into the mid wing's
dowel holes. Also apply some epoxy on the dowels. Insert the
dowels up to the mark you just made, so that just 1/4" [6.3mm]
of each dowel protrudes. Clean up the excess epoxy.
❏
6. Feel through the MonoKote in the center section of the
wing for the wing bolt holes. Remember that there are two of
them. Remove the MonoKote both at the bottom and top
surface of the wing.
❏
1. The first steps in the construction of this wing will be
the installation of the ailerons and the aileron servos. The
process described here will explain how to install the right
aileron and the right aileron servo. The process has to be
repeated again to install the left aileron and the left aileron
servo, or you can work on both at the same time.
❏
2. Locate the top wing and the right aileron.
❏ ❏
3. Locate the pre-cut hinge slots on the top wing's
trailing edge and the leading edge of the aileron. Drill a 3/32"
[2.4 mm ] hole, 1/2" [12mm] deep in the center of each hinge
slot to allow the CA to “wick” in. Follow-up with a #11 blade
to clean-out the slots. Hint: If you have one, use a high-
speed rotary tool to drill the holes.
❏ ❏
4. Use a sharp #11 blade to cut a strip of covering
from the hinge slots in the wing and aileron.
AWAY FROM THE SLOT
CUT THE COVERING
DRILL A 3/32" HOLE
1/2" DEEP IN THE CENTER
OF THE HINGE SLOT
Assemble the Top Wing
10