Great Planes Giant Revolver ARF - GPMA1425 - Manual (Page 9)

9
❏
3. Slide the stab assembly onto the carbon fi ber tubes, fl ush
to the fuselage. Secure the stab to the fuselage with two 4-40
x1/2" [13mm] socket head cap screws, #4 lock washers and
#4 fl at washers. Be sure to use thread locker on each of the
bolts. Do this for both halves of the stab.
Install the Elevator Servos
Note: Steps 1 and 2 describe the installation of the servo
lead for the elevator servos. The installation described uses
one extension and a “Y” connector. Some might prefer a
separate line for each servo. Either method is acceptable.
❏
1. Install a 36" [914mm] servo extension into the tube, sliding
the extension to the back of the fuselage. When it is through
the tube pull the extension outside one of the servo openings.
❏
2. Install a “Y” connector onto the servo extension. Secure
the connection with shrink tubing, tape or some other method
to secure the connection. Note: You may choose to use two
leads for the servos instead of the “Y” connector.