Great Planes Giant Revolver ARF - GPMA1425 - Manual (Page 18)

18
choke servo you should know that the location of the servo
will make it a little more diffi cult to tighten the wing attachment
bolt. If you will be using a manual choke skip ahead to step 24.
❏
16. Locate the
plywood choke servo
tray parts and the
two hardwood blocks.
Glue the tray together
as shown.
❏
17. Place the tray on the same side of the fuselage as the
throttle servo, against the wing tube and the slot in the battery
tray. Drill a 1/16" [1.6mm] hole through the tray. Secure the
choke servo tray with four #2 x 3/8" [10mm.] screws and #2
washers.
❏
18. Install the choke servo into the tray using the hardware
that came with the servo. Install a short 5/8" [16mm] servo
arm on the servo.
❏
19. Install the remaining outer pushrod tube through the
hole in the fi rewall in line with the choke, into the fuselage
and through the hole in the support former and resting in the
notch in the former ahead of the wing tube. Mark the tube
where the tube contacts the fi rewall and formers. Remove the
tube and then roughen the tube with sandpaper in the areas
that contact the fi rewall and the formers. Reinstall the tube
and glue it to the fi rewall and formers.
❏
20. Locate the 3mm plywood half ring plate. Glue it in place
to the pushrod tube, securing it to the former.
❏
21. Locate the remaining nylon ball link. Cut ¼" [6mm] from
the end of the ball link.