Great Planes Giant Revolver ARF - GPMA1425 - Manual (Page 21)

21
❏
4. In order to fi t the cowl over the engine and muffl er you
will need to shorten the exhaust pipes of the muffl er. If you are
installing the DLE 55 and the recommended J-Tec muffl er you
will need to shorten the pipes by approximately 2-1/4" [57mm].
You can do this with a hack saw or a high speed motor tool
and cut-off wheel. Shorten the exhaust pipes as needed.
❏
5. Install the muffl er and cowl. Mark the areas of the cowl
that need to be removed for muffl er clearance and remove
those areas.
6. Install the switch and charge jack for the engine ignition
module. We installed them near the front of the fuselage to
maintain separation between the ignition and radio system.
❏
7. Following the instructions with the engine, install the
ignition module and battery. We have provided room on the
side of the fuselage for the battery and you will be able to fi t
the ignition module on top of the fuselage. The battery and
the ignition module should be mounted with foam underneath
them and secured with the included tie-wraps.
❏
8. Make all of the connections between the switch, charge
jack, battery and the ignition module. Secure the connections
with heat shrink tubing, tape or some other method for securing
the connections. If you have not already secured the engine,
secure the engine to the stand-offs with the bolts that came
with the engine. Be sure you apply thread locking compound
to the bolts before tightening them.