Great Planes F1 Rocket Evo GP/EP ARF - GPMA1030 - Manual (Page 7)

7
❏ ❏
6. Use the strings taped inside the aileron servo hatches
to pull the servo leads through the wing ribs. After pulling the
servo leads through the wing, insert the connector through
the hole in the top of the wing.
❏ ❏
7. Position the aileron servo hatch covers in place. Drill
1/16" [1.6mm] holes through each of the four holes in the
servo covers and into the hardwood blocks. Thread a 5/64"
x 3/8" [2 x 10mm] washer head wood screw into each hole
you drilled and back it out. Apply a drop of thin CA glue into
each hole to harden the wood. When the CA glue has dried,
thread a 5/64" x 3/8" [2 x 10mm] washer head screw into
each of the four holes. When positioning the hatch be sure
the servo arm is towards the wing tip.
❏ ❏
8. Mark the location for the control horn onto the aileron
with a fi ne tip, felt tip marker. The mark can be removed later
with a paper towel and alcohol.
Hinge Line Hinge Line
Correct Incorrect
❏ ❏
9. Position the control horn centered on the mark you
made, positioning it as shown. Drill a 1/16" [1.6mm] hole