Great Planes 12V 12A Power Supply - GPMP0901 - Manual (Page 2)

CASE
The case is vented to allow suffi cient air-fl ow for proper cooling. ALWAYS have at least one inch of unobstructed area around the case
to allow the fan to properly cool the power supply.
WARNING: NEVER set any objects such as nuts, screws, washers, etc. on top of the case because they could very easily fall through
the vents and cause permanent damage to the power supply.
WARNING: NEVER stack a charger or any other device on top of the case as it will prohibit proper cooling and could cause permanent
damage to the power supply.
CONNECTING EXTERNAL DEVICES
Always connect the red (+) positive lead from your charger or other external device to the red (+) positive terminal on the power supply,
and the black (-) negative lead from your charger or other external device to the black (-) negative terminal on the power supply.
Note: The black and red terminal caps can be unscrewed and removed if needed.
WARNING: Do not allow wires or other metal objects to accidentally make contact simultaneously with both terminals, as a short
circuit condition will exist.
WARNING: ALWAYS ensure polarity is correct when connecting external devices to the power supply. Reverse polarity will not
damage the power supply but it may damage the external device.
WARNING: NEVER attempt to connect batteries directly to the output of the power supply!
SAFETY FEATURES
The Electrifl y 12 Amp Power Supply has a 12 amp solid-state current limiter for overload protection, plus short circuit protection. If
either of these conditions occur, disconnect the supply from the AC input, wait approximately 15 seconds to allow the device to reset,
and then re-connect to the AC input.
A built-in top mounted cooling fan keeps electronics cool to help maintain optimum effi ciency and extend the life of the power supply.
WARNING: Do not block the air vents on the power supply. Make sure there is ample room for air to enter and leave the power supply
so heat can dissipate effi ciently.
1-YEAR LIMITED WARRANTY – *USA AND CANADA ONLY
ElectriFly warrants this product to be free from defects in materials and workmanship for period of one (1) year from the date of
purchase. During that period, ElectriFly will, at its option, repair or replace without service charge any product deemed defective due
to those causes. You will be required to provide proof of purchase (invoice or receipt). This warranty does not cover damage caused
by abuse, misuse, alteration or accident. If there is damage stemming from these causes within the stated warranty period, ElectriFly
will, at its option, repair or replace it for a service charge not greater than 50% of its then current retail list price. Be sure to include
your daytime telephone number in case we need to contact you about your repair. This warranty gives you specifi c rights. You may
also have other rights, which vary from state to state.
For service on your ElectriFly product, warranty or non-warranty, send it post-paid and insured to:
HOBBY SERVICES
3002 N. Apollo Drive, Suite 1
Champaign, IL 61822
(217) 398-0007
[email protected]
*For warranty and service information if purchased outside the USA or Canada, see the additional warranty information insert (if
applicable) or ask your retailer for more information.
www.electrifl y.com
Contents © Copyright 2008 Made in Hong Kong GPMP0901MNL V1.0