Graph Tech Ghost Acoustic MIDI - Manual (Page 24)

center-to-center between pots: 2-1/2” (63.5mm)
mounting hole diameter: 9/32” (7.1mm)
Drill three 9/32” (7.1mm) diameter holes to
mount the potentiometers. Two of these holes
must be 2-1/2” (63.5mm) apart, center-to-
center, to accommodate the two pots that
are mounted on the Tone Control’s PC Board.
ited by the wiring harness on the middle pot, and
placement of the Tone Control itself. Check inside
the guitar to make sure there are no obstructions,
and that the harnesses to the other components
are long enough to reach. Mark the location of the
holes on the top through the centers of the wash-
ers, then remove the washers and set them aside.
22