Graph Tech Nut - Manual

LOW E = .010” GAP
HIGH E = .006” GAP
STEP 1. Remove the strings. Trace around
(score) every edge of the nut with an
exacto knife to prevent lacquer sticking
to the nut and the neck and chipping
away. STEP 2. If the nut is not sitting in a slot,
usually a light tap with a small block will
set it free. If it is sitting in a slot, gently
tap it out sideways using a hammer and
a screw driver.
STEP 3. When it is sticking out the side,
pull it out in the same direction with a
pair pliers, like you would a tooth.
Scrape or file the nut slot free from old
glue and finish residue while making
sure that slot remains square. STEP 4. See if the Graph Tech nut fits into
the slot, without forcing it. If it’s too thick,
place a 400 to 600 grit sand paper face
up on a flat surface and sand down the
sides of the nut until it fits in the slot
snugly but is easily removable.
STEP 5. Restring the high and low E
strings and tune to pitch to check for
correct height. Pushing down on the
third note of the low E string should
result in a .010” gap between the string
and the first fret; high E string should be
.006” STEP 6. Once you’ve done the thickness
and the height, you just need to sand the
ends of the nut so that they are flush
with the neck. Just use a pencil and mark
the ends of the nut that are sticking out,
remove it from the neck and sand it to
your marks.
NUT INSTALLATION INSTRUCTIONS
2
3 4
5 6
1
NEED HELP? Contact GRAPH TECH GUITAR LABS at 604-940-5353, via e-mail at
[email protected], or consult our website at www.graphtech.com