Graph Tech Bridge Pin - Manual

NEED HELP? Contact GRAPH TECH GUITAR LABS at 604-940-5353, via e-mail at
[email protected], or consult our website at www.graphtech.com
Pull up on the string to slide the ball
end up the bridge pin and anchor it
against the bridge plate, then push the
pin down into the tapered hole. The pin
does not have to be tight to hold the
string firmly. Push gently to seat the pin.
4
Align the string with the groove in the
bridge pin, and let the ball end extend
beyond the end of the pin. Insert the ball
end and the bridge pin half way into the
tapered hole in the bridge.
3
Remove your old bridge pins using
your fingers or a pin puller like the one
on the end of most string winders.
2
Loosen all six strings. Reduce the
tension until they are loose enough that
the notes can no longer be heard when
a string is plucked.
1
BRIDGE PIN INSTALLATION INSTRUCTIONS