Grant Instruments T100-MST20 - Manual (Page 10)

31083 V2 T100-MST20
Page 9 Operating Manual
www.grantinstruments.com
5.2.3 Setting the control temperature
The temperature of the bath liquid can be set using the S button.
1. Whilst the display is showing the bath temperature, press the S button. This will
cause the display to flash indicating that it can be set.
2. Use the main dial to set the desired temperature.
If no key is pressed for 10 seconds then the display will revert back to showing the
bath temperature and the set temperature will remain at its original value.
3. Press the S button to store the requested value and the display will revert to showing
the bath temperature.
If the temperature selected is higher than the current liquid temperature, the heater
light will come on.
5.2.4 Configuring a preset
The T100 contains three presets which can be configured to different set temperatures to
allow the bath to be conveniently run at frequently used temperatures. Use the method
below to configure preset 1; other presets can be set in a similar manner.
Be aware that once a preset has been saved using the steps below, it will automatically
start once all the steps have been completed.
1. Press the F button and rotate the dial until the display shows “t-1”.
The display will alternate between the preset number and its temperature.
2. Press the S button to select the preset.
3. Use the dial to set the desired preset temperature.
If no key is pressed for 10 seconds then the display will revert back to showing the
bath temperature and the preset temperature will remain at its original value.
4. Press the S button to save the preset temperature.
The preset will automatically start as soon as the value is saved.
Preset temperatures and set temperatures are limited to the model type and the liquid
selection. The T100 settable range is between 0 and 100°C. The factory preset settings
are shown in the table below.
Preset Set temperature range
t-1 37°C
t-2 56°C
t-3 72°C
5.2.5 Running a bath preset
1. Press the F button and rotate the dial until the display shows the correct preset.
2. Press the S button to select the preset.
3. Press the S button to set the bath to the preset temperature.