GME TX6100 - Manual (Page 7)

TX6100 INSTRUCTION MANUAL PAGE 7
Your TX6100 is powered by a 7.4 volt
1700 mAh Li-Ion battery pack. When the
battery pack is new, it should be fully
charged before being used for the first
time. If left unused, your TX6100’s battery
pack will discharge itself within a few
months. If you have not used your TX6100
for some time, you will need to recharge
the battery pack before use.
WARNING: Use only the approved
GME charger. The use of other types may
be dangerous and will void your GME
warranty.
To fit the battery pack
1. Locate the bottom of the battery pack
into the two slots in the base of the
radio frame.
2. Press the top of the battery pack in to
place against the radio until it ‘clicks’.
To remove the battery pack
1. Slide the battery retaining clip
downward while pulling the top of the
battery away from the radio.
2. Lift the battery pack upward to clear
the slots at the bottom of the radio.
poWering tHe radio
To Remove Battery Pack
Swing
Away
Slide
Down
To Refit Battery Pack
Press Press