GME TX6100 - Manual (Page 11)

TX6100 INSTRUCTION MANUAL PAGE 11
Channel
Selected receive
Channel transmit
Channel
1 1 31
2 2 32
3 3 33
4 4 34
5* 5* 35*
6 6 36
7 7 37
8 8 38
41 41 71
42 42 72
43 43 73
44 44 74
45 45 75
46 46 76
47 47 77
48 48 78
scAn key
The SCAN key is a dual function key that
controls both Scan and Memory Functions.
Scanning Function
Channel scanning allows you to monitor
selected channels automatically for
incoming signals. While the radio is
scanning, the MODE setting key is
disabled.
To select channels for scanning:
1. Press the or keys to select the
required channel.
2. Press and hold the SCAN key until the
radio beeps. ‘M’ will appear on the
display indicating the selected channel
is now stored in the Scan Memory.
3. Repeat to store further channels into
the Scan Memory.
4. To remove a channel from the Scan
Group, press and hold the SCAN key
again. ‘M’ will disappear from the
display.
To scan the selected channels:
Briefly press the SCAN key. ‘SCAN’ will be
displayed and the radio will show rapidly
changing channel numbers as it scans
through the channels. While scanning,
briefly press the or keys to select the
scan direction.
To exit the scan mode, briefly press the
SCAN key again. The TX6100 will return
to normal operation and ‘SCAN’ will
disappear from the display.
NOTE: There must be at least 2 channels
in Scan Memory otherwise the radio will
not scan.
Scanning Features
• If a signal is received, the scan is
paused, allowing you to transmit and
receive on that channel. The radio will
automatically resume scanning a few
seconds after the last reception or
transmission.