GME TX6100 User Manual
Page 14

PAGE 14
INSTRUCTION MANUAL
TX6100
To enable DCS on the radio:
1. Select a channel that has a DCS
code selected.
2. Press and hold the
SQL
key for about
2 seconds. The ‘DCS’ icon will appear
on the display. DCS is now enabled on
ALL channels that have DCS codes
selected.
To Disable DCS on the Radio:
1. Select a DCS enabled channel using
the or keys. The DCS code will be
displayed on that channel.
2. Press and hold the
SQL
key for about
2 seconds. The ‘DCS’ icon and DCS
code will disappear from the display
indicating DCS is no longer activated.
NOTE:
DCS is only enabled on those
channels with DCS codes selected. All
other channels will continue to operate
normally.
3. Transmitter Power
The transmitter power can be set to High
(5 watts) or Low (1 watt). The power
setting applies to all channels
To set the transmit power:
From the Standby mode;
1. Press the
MODE
key THREE (3) times
to select the power setting mode.
‘Po’ will be displayed and ‘HI’ or ‘LO’
will be flashing on the display.
2. Press the or keys to select the
required power setting. Select HI for
high power or LO for low power.
3. Press and hold the
MODE
key (or press
the
PTT
key momentarily) to confirm
and store your selection.
The TX6100 should now display the
selected channel number along with ‘HI’
or ‘LO’ to indicate the transmit power you
have set.
4. VOX Settings
The VOX feature lets you have handsfree
conversations. When you speak, the
microphone automatically detects your
voice (or other nearby sound) causing
the radio to transmit without the need to
press the
PTT
switch.
To set radio for VOX operation:
From the Standby mode;
1. Press the
MODE
key FOUR (4) times
to select the VOX setting mode. will
flash on the display.
2. Press the or keys to select
the sensitivity from 1 (minimum) to
7 (maximum). The minimum setting
requires a louder voice to activate
the VOX. The maximum setting will
activate the VOX with a much softer
voice.
3. To disable the VOX completely, set the
VOX sensitivity to
oFF.
4. Press and hold the
MODE
key (or
press the
PTT
key momentarily) to