GME TX6100 User Manual
Page 13

TX6100
INSTRUCTION MANUAL
PAGE 13
not using CTCSS you will need to either
disable CTCSS on that channel or set the
CTCSS code to
oFF
as described below.
A table of installed CTCSS codes appears
on page 17.
To select a CTCSS code:
From the Standby mode;
1. Select the required channel using the
or keys.
2. Press the
MODE
key ONCE (1) to
select the CTCSS setting mode. ‘CTC’
will flash on the display.
3. Press the or keys to select
the required CTCSS code. (A list of
available codes is shown on page 17).
NOTE:
To turn CTCSS off on this channel,
set the CTCSS code to
oFF
.
4. Press and hold the
MODE
key (or press
the
PTT
key momentarily) to confirm
and store your selection.
To enable CTCSS on the radio:
1. Select a channel that has a CTCSS
code selected.
2. Press and hold the
SQL
key for about
2 seconds. The ‘CTC’ icon and CTCSS
code will appear on the display. CTCSS
is now enabled on ALL channels that
have CTCSS codes selected.
To Disable CTCSS on the Radio
1. Select a CTCSS enabled channel using
the or keys. The CTCSS code will
be displayed on that channel.
2. Press and hold the
SQL
key for about
2 seconds. The ‘CTC’ icon and CTCSS
code will disappear from the display
indicating CTCSS is no longer
activated.
NOTE
:
CTCSS is only enabled on those
channels with CTCSS codes selected. All
other channels will continue to
operate normally.
2. Digitally Coded Squelch
Digitally Coded Squelch (DCS) is also a
squelch quieting system that allows
groups to share the same channel without
disturbing each other. There are 104 DCS
codes available.
To Select DCS on the Radio
From standby mode:
1. Select the required channel using the
or keys.
2. Press the MODE key TWICE (2) to
select DCS setting mode ‘DCS’ will
flash.
3. Press the or keys to select the
required DCS code. (A list of available
codes is shown on page 18.)
4. Press and hold the
MODE
key (or press
the
PTT
key momentarily) to confirm
and store your selection.