GME TX3340 - Manual (Page 20)

PA G E 2 0 i n s t r u c t i o n m A n uA l t X 3 3 4 0
antenna installation
it is essential to select a good quality, high efficiency, 477 mhz
antenna. A poor quality antenna or one not designed for the
specific frequency band you are using will give very
poor performance.
GmE have a wide range of suitable 477 mhz uhF cB antennas
to suit most installations and applications. We recommend
contacting your local GmE retailer for advice.
connect to the antenna cable to the rear antenna socket using
a Pl259 coaxial connector.
Noise Sup pres sion
the inherent design of Fm transceivers result in a high level
of resistance to ignition and electrical interference. however
in some installations it may be necessary to take additional
steps to help reduce or eliminate noise interference. during
installation, try to route the dc battery leads, the antenna lead
or any accessory wires away from the engine compartment,
ignition or alternator wiring. if the noise continues, it may be
necessary to fit a suppression kit in which case we recommend
you consult an auto electrician for advice specific to
your installation.
higher frequency electrical interference cause by electric motors
can be suppressed directly at the motor terminals.
Fitting the LCD controller microphone
Mounting the cradle
the mounting bracket can be oriented the arms extending
either forward or backwards to adjust the position of the front
panel with reference to the mounting point
slide microphone
into the mounting clip