GME TX3340 User Manual

Page 12

PA G E 1 2

i n s t r u c t i o n m A n uA l

t X 3 3 4 0

entering a selCall iDent
1. Press the CALL button. ‘cAll to’ is displayed, along with

the last sent or received selcall ident. the radio is now in
‘cAll to’ mode.

NOTE: if an AlPhA label is displayed you will need to switch
to numEric mode. to toggle between AlPhA mode and
numEric mode, briefly press the F key followed by the
ALPHA key.

2. Enter the required selcall ident as follows:

(a) Press and hold the PRI key until the radio beeps. the

right-hand digit of the selcall ident will flash.

(b) Press the or keys to select the required number in

the flashing digit position.

digit position.

(d) repeat steps (b) and (c) to enter all 5 digits as required.

the selcall number is now ready to send.

senDing selCall
With the selcall number displayed, press and hold the CALL
button for 2 seconds. the radio will transmit the selcall ident.

NOTE: if the call is not sent within 10 seconds of entering the
last ident digit the call mode will time out and the radio will
return to normal mode. to exit cAll to mode without sending
the selcall briefly press the CALL button.

Call aCKnowleDge
if your selcall transmission is successful, the radio you called
should respond with an ‘acknowledge’ signal - usually two
quick beeps. this will confirm to you that the radio you called
is now alerting its user to your signal.

storing selCall iDents
your tX3340 is fitted with 10 user programmable selcall
ident memories, allowing you to store up to 10 frequently
used selcall idents. the memories are accessed by pressing
the CALL button, then the or keys to scroll through the
memories. ident memories are labelled ‘c0’ to ‘c9’.
To store a Selcall Ident in memory

1. Press the CALL button to select the cAll to mode. ‘cAll

to’ is displayed along with the last sent or received selcall
ident.

2. Press the or keys to select the required ident memory

(locations ‘c0’ to ‘c9’).

TIP: if the radio displays letters instead of numbers in the
selcall ident position, your radio is in AlPhA mode. to switch
back to numEric mode, briefly press the F key followed
immediately by the ALPHA key. ’numEr’ will be displayed for
a few seconds in the ident position.

3. With the required memory location displayed, enter the

selcall ident as follows:
(a) Press and hold PRI key until the radio beeps.

the right-hand digit of the selcall ident will flash.

(b) Press the or keys to select the required number in

the flashing digit position.

digit position.

(d) repeat steps (b) and (c) to enter all 5 digits as required.
(e) now press and hold the PRI key. the entire ident will

flash for a few seconds then the radio will beep as the
new ident is stored.

reCalling selCall iDents FroM MeMory
1. Press the CALL button to select the cAll to mode. ‘cAll

to’ is displayed along with the last sent or received
selcall ident.

2. Press the or keys to select the required ident memory

in locations ‘c0’ to ‘c9’.