GME TX3200 - Manual (Page 14)

14
SPECIFICATIONS
GENERAL
Compliance:
Frequency range:
Number of Channels:
Channel Spacing:
Operating Mode:
Scanning Speed:
Antenna Impedance:
Nominal Battery
Voltage:
Operating Voltage
Range:
Battery Polarity:
Standard Test Voltage:
Overvoltage
Protection:
Reverse Voltage
Protection:
Overcurrent
protection:
Operating
Temperature:
TRANSMITTER
RF Output:
Spurious Emission:
Frequency Error:
Modulation:
Maximum Deviation:
Transmit Frequency
Response:
Demodulation Audio
Signal to Noise:
Current Consumption:
RECEIVER
RF Bandwidth:
Intermediate
Frequencies:
Sensitivity:
Selectivity:
Intermodulation
Immunity:
Blocking Immunity:
Spurious Response
Immunity:
Audio Output Power:
Audio Signal to Noise:
Receiver Frequency
Response:
Current Consumption:
Conducted Spurious
Emission:
MECHANICAL
SPECIFICATION &
CONNECTIONS
Dimensions:
Weight:
12 Volt Power Supply:
Antenna:
External Speaker:
Microphone Port:
< 5 MHz
21.4 MHz, 455 kHz
- 122 dBm for 12 dB
SINAD unweighted.
- 6 dB ± 7.5 kHz
- 72 dB ± 25 kHz
- 78 dB
- 95 dB
- 70 dB
3 Watts average into
4 Ohms.
> 45 dB unweighted.
- 6 dB per octave
de-emphasis, 300 Hz to
3 kHz, + 1, - 3 dB
< 190 mA muted.
750 mA Full Volume.
< - 70 dBm
128mm (W) x 117mm (L)
x 29mm (H)
456 grams
Two core cable with
bulkhead connector in
rear panel.
SO239 panel socket.
3.5 mm Mono Jack.
6 Way telephone style
with rubber strain relief.
Specifications are typical unless otherwise
indicated and may be subject to change
without notice or obligation.
Meets AS/NZS 4365 for
radio communications
equipment in the
UHF citizen band and
personal radio service.
476.425 MHz -
477.400 MHz
40
25 kHz
Simplex or half Duplex
with repeater talk around.
50 ms per channel
(20 channels per second)
50 Ohms nominal.
12 VDC
10 to 16 VDC
Negative Earth
13.8 VDC
30 VDC maximum. At
18 VDC the channel
display flashes “Hi DC”
for 5 seconds on receive
and the RF power is
reduced and TX flashes
on transmit.
Diode Crowbar.
In-line 3 Amp fuse.
-10° C to 60° C
5 Watts
< - 70 dBc
< ± 5 PPM
FM
< ± 5 kHz at + 20 dB
AF Limiting.
+ 6 dB per octave, 300
Hz to 3 kHz, + 1, - 3dB
> 45 dB unweighted
1.7 Amps with 50 Ohm
termination.