GME TX675TP User Manual
Page 15
t X 6 7 5
i n s t r u c t i o n m A n uA l
PA G E 1 5
4
VoX settings
Vo
oF/1 – 3
5
squelch level setting
sq
Aut/1 – 5
6
roger Beep setting
rb
oF/on
7
Button Beep selection
bP
oF/on
8
call Alarm selection
cl
oF/1 – 5
9
Dual watch channel
du
oF/on 1 – 80
note:
ctcss/Dcs and transmit power settings are inhibited on channels 5/35
(emergency channel).
using the menu
to access the menu, press and hold the menu key until the radio beeps.
menu options will appear in the order listed above.
to step to the next menu item press the menu key again. to change the options in
the selected menu press the or keys. to store your selection and exit the menu
press the Ptt.
DuPleX moDe selection
the Duplex option only appears in the menu if a repeater channel (1 – 8 or 41 – 48)
was selected prior to entering the menu.
to enable Duplex on the selected repeater channel
1. select a repeater channel 1 – 8 or 41 – 48 using the or keys.
2. Press and hold the menu key until the radio beeps. the
icon will flash.
3. Press the or keys to toggle ‘on’ (duplex enabled) or ‘oF’ (duplex disabled)
on the display.
4. Press the Ptt to store your setting and exit the menu.
when Duplex is enabled on a repeater channel, the
icon will be displayed on
that channel.
ctcss anD Dcs coDe selection
the radio is fitted with both ctcss and Dcs systems. there are 50 ctcss tones and
104 Dcs codes. the Dcs codes and the ctcss tones are accessed through the same
menu (see table below). when ctcss tones are being selected ‘ct’ is displayed.
to access Dcs codes scroll past ctcss tone 50 until ‘dt’ is displayed.
oFF
ct (ctcss)
Dt (Dcs)
01 50
001 104