GMC 2006 Canyon - Manual (Page 328)

To replace one of these bulbs, do the following:
1. Open the tailgate. See Tailgate on page 2-9 for
more information.
2. Remove the two rear
lamp assembly screws
near the tailgate latch.
3. Pull out the lamp assembly.
4. Turn the bulb socket counterclockwise to remove it
from the taillamp housing.
5. Pull the old bulb straight out from the socket.
6. Press a new bulb into the socket and turn the socket
clockwise into the taillamp housing until it is tight.
7. Reinstall the rear lamp assembly and tighten the
screws.
Replacement Bulbs
Exterior Lamp Bulb Number
Center High-Mounted
Stoplamp (CHMSL)
912
Headlamps
Composite High-beam 9005
Composite Low-beam/Daytime
Running Lamp (DRL)*
9006
Sealed-beam H6054
Parking/Front Turn Signal/Daytime
Running Lamp (DRL)*
3757KA
Parking Lamp (Inboard) 3157A
Stoplamp, Rear Turn Signal,
Taillamp, and Back-up Lamp
3057
*Your vehicle may have the DRL function either in the
low-beam headlamp or the parking lamp.
For replacement bulbs not listed here, contact your
dealer.
5-52