GIN Genie Race 3 - Manual (Page 42)

Inspection checklist
In addition to regular pre-flight checks, the Genie Race 3 should be inspected thoroughly on
every rescue repack of 150 days. Additional inspections should be performed after any crash, bad
landing or take off, or if there are any signs of damage or undue wear. Always seek professional
advice whenever in doubt.
The following checks should be carried out
Check all webbing, straps and buckles for wear and damage, especially the areas that are not
easily seen, such as the inside of the carabiner hook-in points.
All sewing must be intact and any anomalies attended to immediately to avoid exacerbation of
the problem.
Special attention should be paid to the rescue installation, particularly the elastic and Velcro
parts.
The seat and back plates must be free from cracks.
The main aluminium carabiners must be replaced at least every 5 years or after 500 hours,
whatever comes first. Impacts may create undetectable cracks that could result in structural
failure under continuous load.
Repairs
The manufacturer or an approved specialist should carry out any repair that involves critical
parts of the harness. This will ensure that the correct materials and repair techniques are used.
42