GIN Genie Race 3 - Manual (Page 16)

16
Before you fly
Make sure your dealer has checked the harness for completeness and basic settings. Your
harness must be assembled by a suitably qualified paragliding professional, for example, your
instructor.
Gin Gliders recommends that assembly be carried out in the following order. If you are in any
doubt whatsoever about this procedure, please seek professional advice from your instructor,
GIN dealer or importer.
Installing the speed system
Assemble the speed system from top to bottom. Pass the cord of the speed bar through the
hole in the neoprene just under the carabiners. Route the cord through the pulley and run it
along the outside of the seat. Pass the cord through a cover on the outside of the bottom plate
through an O-ring. Tie the cord to the attachment points of the speedbar. Attach the elastic cord
to the attachment point on the third step and tie it to the foot plate.
CAUTION: Make sure that the speed
system is not too short. The front
risers of your paraglider must not
be pulled down in normal
(unaccelerated) flight.
1 2